Setting up a Floboss 103

The configuration of a Floboss 103 is based on the ROM set installed and can therefore be loaded from predefined files. Selecting the config type will automatically select the correct Modbus map to use and will build screens and reports accordingly.

Setting up a Floboss 103

To setup a Floboss 103:

  • Click 'Add Configuration' from the configurations screen
  • Enter a 'Configuration Name' to identify the configuration.
  • Select "Fisher Floboss 103" from the 'RTU Type' menu.
  • Choose the type of Floboss from the Config Type menu. This should reflect the ROMs installed in the Floboss.
  • Click the 'Next' button.

Setting up a Floboss 103Setting up an Omni RMC

With the TCP protocol selected, specify the fields as follows:

Field Description
Protocol Select the protocol by which you wish to communicate with the RTU.
IP Address Enter the IP address of the RTU.
Slave Address This is the slave address that the RTU will use.
Port Enter the port number of the RTU.

With the serial protocol specified, specify the fields as follows:

Field Description
Protocol Select the protocol by which you wish to communicate with the RTU.
Serial Port This is the serial port that the RTU is connected to.
Slave Address This is the slave address that the RTU will use.
Serial Port Speed This is the baud rate the connection will use.
Data Bits This is the amount of data bits that the connection will use. The default value is 8.
Stop Bits This is the amount of stop bits that the connection will use. The default value is 1.
Parity Bits This is the parity that the connection will use. The default value is None.

Setting up an Floboss 103

To add the configuration:

  • Click "Next" to launch your browser and proceed to add sites and RTU's.
  • Or Click "Finish" to return to Profile.

Profile™ Configuration Manual